Dell PowerVault NX3000 - Manual (Page 82)

82
Installing System Components
1 If present, remove the front bezel. See "Removing the Front Bezel."
2 If a drive blank is present in the bay, remove it. See "Removing a Hard-
Drive Blank."
Figure 3-5. Installing a Hot-Swap Hard Drive
3 Install the hot-swap hard drive.
a Press the button on the front of the drive carrier and open the handle.
b Insert the hard-drive carrier into the drive bay until the carrier
contacts the backplane.
c Close the handle to lock the drive in place.
4 If applicable, install the bezel. See "Installing the Front Bezel."
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.
1 release button 2 hard drive carrier handle
2
1