Dell PowerVault NX3000 - Manual (Page 141)

Installing System Components
141
Figure 3-34. Removing and Installing the Control Panel
Removing the Control Panel Board
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
1 front panel screw (Torx) 2 display module cable
3 control panel board 4 control panel cable
5 mounting screws (3 Torx) 6 display module
5
2
3
4
6
1