Dell PowerVault NX3000 - Manual (Page 91)

Installing System Components
91
Figure 3-9. Removing or Installing a USB Memory Key
5 Close the system. See "Closing the System."
6 Reconnect the system to power and restart the system.
Integrated Dell Remote Access Controller 6
(iDRAC6) Enterprise Card (Optional)
The optional iDRAC6 Enterprise card provides a set of advanced features for
managing the server remotely.
Installing an iDRAC6 Enterprise Card
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel. See "Back Panel Features and Indicators" for the port
location.
4 If installed, remove all expansion cards from expansion-card riser 1. See
"Removing an Expansion Card."
1 control panel board 2 USB memory key connector
3 USB memory key
2 3 1