Dell PowerVault NX3500 - Manual (Page 72)

72 Installing System Components
4 Remove the expansion NIC card from the expansion-card slot.
See "Replacing an Expansion NIC Card" on page 60.
5 Pull back slightly on the two tabs at the front edge of the card and gently
lift the front edge of the card off of the retention standoffs.
As the card releases from the standoffs, the connector under the card
disengages from the system board connector.
6 Slide the card away from the back of the system until the RJ-45 connector
is clear of the back panel.
Lift the card out of the system.
7 Angle the new card so that the RJ-45 connector fits through the back-panel
opening. See Figure 2-12.
8 Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board, and lower
the card into place. See Figure 2-12.
When the front of the card is fully seated, the plastic standoffs snap over
the edge of the card.
Figure 2-12. Replacing an iDRAC6 Enterprise Card
1 VFlash media slot 2 iDRAC6 Enterprise card connector
3 retention standoff posts (2) 4 iDRAC6 Enterprise card
2
1
3
4
book.book Page 72 Monday, January 24, 2011 12:24 PM