Dell PowerVault NX3500 - Manual (Page 45)

About Your Solution 45
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty keyboard or
mouse controller chip.
Reseat the memory modules.
See "Troubleshooting
System Memory" on page 97.
If the problem persists, see
"Getting Help" on page 113.
Unsupported CPU
combination.
Unsupported CPU
stepping
detected.
Processor is not supported by
the system.
Install a supported processor.
See "Processor" on page 73.
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 67.
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected: x,
x,...
Invalid memory
configuration.
Memory modules are
mismatched in the
specified slots.
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 67.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error occurred
and caused the system to
reboot.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 93 for
any faulty components
specified in the SEL.
Table 1-4. System Messages (continued)
Message Causes Corrective Actions
book.book Page 45 Monday, January 24, 2011 12:24 PM