Dell Latitude D430 (Mid 2007) User Manual
Page 48
48
Setting Up and Using Networks
The Order Confirmation for Your Computer
The order confirmation that you received when you ordered your computer lists the hardware and
software that shipped with your computer.
Setting Up a New WLAN Using a Wireless Router and a Broadband Modem
1 Contact your Internet service provider (ISP) to obtain specific information about the connection
requirements for your broadband modem.
2 Ensure that you have wired Internet access through your broadband modem before you attempt to set
up a wireless Internet connection (see "Connecting a Network or Broadband Modem Cable" on
3 Install any software required for your wireless router. Your wireless router may have been shipped with
an installation CD. Installation CDs usually contain installation and troubleshooting information.
Install the required software according to the instructions provided by the router manufacturer.
4 Shut down your computer and any other wireless-enabled computers in the vicinity through the Start
or menu.
5 Disconnect your broadband modem power cable from the electrical outlet.
6 Disconnect the network cable from the computer and the modem.
7 Disconnect the AC adapter cable from your wireless router to ensure that there is no power connected
to the router.
NOTE:
Wait for a minimum of 5 minutes after disconnecting your broadband modem before you continue with the
network setup.
8 Insert a network cable into the network (RJ-45) connector on the unpowered broadband modem.
9 Connect the other end of the network cable into the Internet network (RJ-45) connector on the
unpowered wireless router.
10 Ensure that no network or USB cables other than the network cable connecting the modem and the
wireless router are connected to the broadband modem.
NOTE:
Restart your wireless equipment in the order described below to prevent a potential connection failure.
11 Turn on only your broadband modem and wait for at least 2 minutes for the broadband modem to
stabilize. After 2 minutes, proceed to step 12.
12 Turn on your wireless router and wait for at least 2 minutes for the wireless router to stabilize. After 2
minutes, proceed to the step 13.
13 Start your computer and wait until the boot process completes.
14 See the documentation that came with your wireless router to set up the wireless router:
• Establish communication between your computer and your wireless router.
• Configure your wireless router to communicate with your broadband router.