Sas/sata backplane board, Figure 3, Installing the sideplane board – Dell POWEREDGE R805 User Manual
Page 53: Removing the sas/sata backplane board
![background image](/manuals/619579/53/background.png)
Installing the Sideplane Board
1.
Insert the sideplane board into sideplane slots along the left wall of the chassis and lower the sideplane board so that the pin collars connect with the
two pins on the system board. Press the sideplane down until sideplane connector is fully seated into the system board connector. See
.
2.
Reattach the control panel cable to the sideplane board.
3.
Replace the storage controller daughter card. See
Installing a SAS Controller Daughter Card
.
4.
.
Figure 3-29. Sideplane Removal and Installation
SAS/SATA Backplane Board
Removing the SAS/SATA Backplane Board
1.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2.
3.
If present, disconnect the optical drive power cable from the SAS/SATA backplane board. See
Removing the Optical Drive from the System
.
4.
Open the drive-carrier release handle on each hard drive and partially extend the drive(s) out of their drive bays. See
Removing a Hot-Plug Hard Drive
5.
Remove the storage controller daughter card. See
Removing a SAS Controller Daughter Card
6.
Disconnect the SAS cable from the backplane connector.
1
sideplane
2
control panel connector
3
control panel cable
4
sideplane release tab (2)
5
pin collar (2)
6
chassis pin (2)
7
sideplane connector
8
system board
9
SAS controller daughter card
10 SAS controller daughter card release handle
11 SAS controller daughter card socket
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.