Closing the system, Connecting drives, Installing the front-panel drive inserts – Dell PowerVault DP100 User Manual
Page 36: Replacing the cover, Installing the bezel

Installing the Front-Panel Drive Inserts
1.
Install the chassis drive insert by sliding the insert into the chassis until tabs on the side of the insert snap into place. See
2.
Install the bezel drive insert by sliding the insert into the bezel until the tabs on the side of the insert snap into place. See
.
3.
.
4.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Closing the System
Replacing the Cover
1.
Ensure that all cables are connected, and fold cables out of the way.
2.
Ensure that no tools or loose parts are left inside the system.
3.
Fit the cover on the side of the system, and slide the cover backward.
4.
Tighten the cover thumbscrew to secure the cover.
Installing the Bezel
To install the bezel, align the hooks at the bottom of the bezel, swing the top of the bezel toward the system, and press the bezel onto the system until it
snaps into place. Using the system key, lock the bezel.
Connecting Drives
1
chassis drive insert
2
bezel drive insert
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer, and protecting against electrostatic discharge.
NOTICE:
You must install both inserts in an empty 5.25-inch drive bay to maintain Federal Communications Commission (FCC) certification of the
system. The inserts also help keep dust and dirt out of the system.