Dell PowerVault DP100 - Manual (Page 56)

5. Press down on the processor socket release lever, then pull the release lever upward to the fully open position. See Figure 3 -23 .
6. Open the processor cover. See Figure 3 -23 .
7. Lift the processor vertically out of the socket. Leave the processor cover and release lever in the open position so that the socket is ready for the new
processor. See
Figure 3 -23 .
Figure 3-23. Removing/Replacing the Processor
Installing a Processor
1. Unpack the new processor and heat sink, if provided.
2. Ensure that the processor socket release lever is in the fully open position.
3. Align the pin 1 corners of the processor and socket. See Figure 3 -23 .
1 heat sink 2 securing clips (2)
1 processor socket release lever 2 processor cover 3 pin-1 locators
4 processor socket 5 processor
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer, and protecting against electrostatic discharge.