Dell PowerVault DP100 - Manual (Page 9)

number. problem persists, see Getting
Help .
Plug & Play Configuration
Error
Error encountered in
initializing PCI device; faulty
system board.
Install the NVRAM_CLR jumper
and reboot the system. See
Figure 6 -1 for jumper location.
Check for a BIOS update. If
the problem persists, see
Troubleshooting Expansion
Cards
. If the problem persists,
see Getting Help .
Primary drive n
configuration error
Primary drive 1 failure
Faulty hard-disk drive.
Replace the hard-disk drive.
See
Troubleshooting SATA
Hard Drives or Troubleshooting
a SAS RAID Controller in for
the appropriate drive(s)
installed in your system.
Read fault
Requested sector not found
Faulty diskette, diskette
drive, optical drive, or hard
drive.
Replace the diskette. Ensure
that the diskette, optical, and
hard-drive cables are properly
connected. See
Troubleshooting a Diskette
Drive
, Troubleshooting an
Optical Drive , Troubleshooting
SATA Hard Drives ," or
Troubleshooting a SAS RAID
Controller
" for the appropriate
drive(s) installed in your
system.
Remote Configuration update
attempt failed
System could not implement
Remote Configuration
request.
Retry Remote Configuration.
ROM bad checksum = address
Faulty or improperly installed
expansion card.
Remove and reseat the
expansion cards. See
Troubleshooting Expansion
Cards
.
SATA Port n hard disk drive
configuration error
SATA Port n hard disk drive
failure
SATA Port n hard disk drive
auto-sensing error
Faulty SATA hard drive.
Replace the hard-disk drive.
See
Troubleshooting SATA
Hard Drives for the
appropriate drive(s) installed
in your system.
SATA Port n hard disk not
found SATA hard drive not
connected to port n.
Ensure that the hard-drive
cable is properly connected.
See
Hard Drives .
If a drive is not connected to
port n, check that the SATA
port is disabled in the System
Setup program. See
Using the
System Setup Program .
Sector not found
Seek error
Seek operation failed
Faulty diskette or hard drive.
Replace the diskette. If the
problem persists, see
Troubleshooting SATA Hard
Drives
or Troubleshooting
SATA Hard Drives for the
appropriate drive installed in
your system.
Shutdown failure Shutdown test failure.
Ensure that all memory
modules are properly installed.
See
Troubleshooting System
Memory . If the problem
persists, see Getting Help .
The amount of system
memory has changed.
Faulty memory module.
See Troubleshooting System
Memory . If the problem
persists, see Getting Help .
The amount of tested memory
is below the minimum system
configuration. System halted!
Invalid memory configuration See Memory .
Faulty memory module.
See Troubleshooting System
Memory . If the problem
persists, see Getting Help .
Time-of-day clock stopped
Faulty battery; faulty system
board.
See Troubleshooting the
System Battery . If the problem
persists, see Getting Help .
Time-of-day not set - please
run SETUP program
Incorrect Time or Date
settings; faulty system
battery.
Check the Time and Date
settings. See "Using the
System Setup Program" in
your User's Guide. If the
problem persists, see
Troubleshooting the System
Battery
.
Timer chip counter 2 failed Faulty system board. See Getting Help .
Unexpected interrupt in
protected mode
Faulty or improperly installed
memory modules or faulty
system board.
Ensure that all memory
modules are properly installed.
See
Memory . If the problem
persists, see Troubleshooting
System Memory . If the problem
persists, see Getting Help .