Dell PowerVault DP100 - Manual (Page 11)

Warning Messages
A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette. Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
Diagnostics Messages
When you run system diagnostics, an error message may result. Diagnostic error messages are not covered in this section. Record the message on a copy of
the Diagnostics Checklist in "Getting Help," and then follow the instructions in that section for obtaining technical assistance.
Alert Messages
Systems management software generates alert messages for your system. Alert messages include information, status, warning, and failure messages for
drive, temperature, fan, and power conditions. For more information, see the systems management software documentation.
Baseboard Management Controller Messages
The Baseboard Management Controller (BMC) enables you to configure, monitor, and recover systems remotely. BMC uses the system's serial port and
integrated NIC1 to support fault logging and SNMP alerting.
For additional information on using BMC, see the documentation for the BMC and systems management applications.
Back to Contents Page
Help .
4-2-2 Shutdown test failure
4-2-3 Gate A20 failure
4-2-4 Unexpected interrupt in protected
mode See Troubleshooting Expansion Cards .
4-3-1 Improperly installed or faulty memory
modules See Troubleshooting System Memory .
4-3-2 No memory modules installed in the
first memory module connector Install a memory module in the first
memory module connector. See
Memory .
4-3-3 Faulty system board Replace faulty system board. See Getting
Help .
4-3-4 Time-of-day clock stopped See Troubleshooting System Memory .
Replace faulty system board. See Getting
Help .
4-4-1 Super I/O chip failure; faulty system
board Replace faulty system board. Faulty
system board. See
Getting Help .
4-4-4 Cache test failure; faulty processor See Troubleshooting the Microprocessor .
NOTE: Warning messages are generated by either the application or the operating system. For more information, see the documentation that
accompanied the operating system or application.
NOTE: If the integrated network controller is used in an Ether Channel team or link aggregation team, the BMC management traffic will not function
properly. For more information about network teaming, see the documentation for the network controller.