Dell PowerVault DP100 - Manual (Page 33)

Back to Contents Page
Installing System Components
Dell™ PowerVault™ 100 Systems Hardware Owner's Manual
This section describes how to install the following system components:
l Diskette drive
l Optical and tape drives
l Hard drives
l Cooling Shroud
l Cooling Fans
l Power supply
l Expansion cards
l Memory
l SAS controller card
l Microprocessor
l System battery
l Front I/O panel
l System board
Recommended Tools
You may need the following items to perform the procedures in this section:
l #2 Phillips screwdriver
l Long #2 Phillips screwdriver (blade at least 6 inches long)
l Small flat-blade driver
l Wrist grounding strap
Inside the System
In Figure 3 -1 , the system cover is opened and the front bezel removed to provide an interior view of the system.
Figure 3-1. Inside the System
Recommended Tools Cooling Fans
Inside the System Power Supply
Opening the System Expansion Cards
Front-Panel Drive Inserts Memory
Closing the System Microprocessor
Connecting Drives Installing a RAC Card
Diskette Drive System Battery
Optical or Tape Drives Front I/O Panel (Service-Only Parts Procedure)
Hard Drives System Board (Service-Only Parts Procedure)
Cooling Shroud