Dell PowerVault DP100 - Manual (Page 8)

configurations.
Keyboard controller failure
Faulty keyboard controller
(faulty system board).
See Getting Help .
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Loose or improperly
connected keyboard cable;
faulty keyboard; faulty
keyboard controller.
Ensure that the keyboard is
properly connected. If the
problem persists, replace the
keyboard. If the problem
persists, see
Getting Help .
Keyboard fuse has failed. Keyboard fuse has failed. Replace the keyboard.
Manufacturing mode detected
System is incorrectly
configured.
Install the NVRAM_CLR jumper
and reboot the system. See
System Board Jumpers for
jumper location.
Memory address line failure
at address, read value
expecting value
Memory double word logic
failure at address, read
value expecting value
Memory odd/even logic
failure at address, read
value expecting value
Memory write/read failure
at address, read value
expecting value
Faulty or improperly installed
memory modules, or faulty
system board.
Ensure that all memory
modules are properly installed.
See
Troubleshooting System
Memory . If the problem
persists, see Getting Help .
Memory tests terminated by
keystroke
The spacebar was pressed
during POST to terminate the
memory test.
Do not press spacebar during
memory test.
More than one RAC detected,
system halted
Verify that the RAC is installed
in the proper PCI expansion
slot (SLOT_5). If a RAC is
installed in any other slot,
remove it.
No boot device available
Faulty or missing diskette
drive, optical drive, or hard
drive.
Check the Integrated Devices
configuration settings in the
System Setup program. See
Using the System Setup
Program
. Ensure that either
SATA Controller, Diskette
Controller, or IDE Controller
is enabled. If the system is
booting from a SCSI controller,
ensure that the controller is
properly connected. If the
problem persists, replace the
drive. See
Hard Drives .
No boot sector on hard-disk
drive An operating system is not on
the hard drive.
Check the hard-drive
configuration settings in the
System Setup program. See
Using the System Setup
Program
.
No timer tick interrupt Faulty system board. See Getting Help .
Not a boot diskette Not a bootable diskette. Use a bootable diskette.
PCI BIOS failed to install
Loose cables to expansion
card(s); faulty or improperly
installed expansion card.
Ensure that all appropriate
cables are securely connected
to the expansion cards. See
Troubleshooting Expansion
Cards
.
PCIe Degraded Link Width
Error:
Embedded
Bus#nn/Dev#nn/Funcn
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed
PCIe card.
Reseat the PCIe cards. See
Expansion Cards . If the
problem persists, see Getting
Help .
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed
PCIe card in the specified slot
number.
Reseat the PCIe card in the
specified slot number. See
Expansion Cards . If the
problem persists, see Getting
Help .
PCIe Training Error:
Embedded
Bus#nn/Dev#nn/Funcn
Faulty or improperly installed
PCIe card.
Reseat the PCIe cards. See
Expansion Cards . If the
problem persists, see Getting
Help .
PCIe Training Error: Slot n
Faulty or improperly installed
PCIe card in the specified slot
Reseat the PCIe card in the
specified slot number. See
Expansion Cards . If the