Dell Latitude XT2 XFR (Late 2009) - Manual (Page 51)

Dell ™ Latitude™ XT2 XFR Service Manual
Page 51 of 94 Version A00-01
4. Loosen and remove the screw holding the stylus bay housing to the chassis.
5. Unthread the cable and connector for the stylus bay.
6. Remove the Stylus Bay from the bottom chassis by lifting up. Being careful not to damage the
grommet that seals to the base.
4.12.2 Installing the Stylus Bay
1. Start by threading the cable and connector through the opening in the chassis.
2. Set the grommet surrounding the cable in the opening to produce a seal.
3. Insert the stylus bay into the chassis being careful with the gaskets around the bay.
4. Insert and tighten the self tapping screw.
4.13 Speaker
WARNING: Before working inside your XT2 XFR, read the safety information that
shipped with your XT2 XFR. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.