Dell PowerVault 715N (Rackmount NAS Appliance) User Manual
Page 81
on and it came back up, I had to wait to access
it. The system appeared to regenerate the RAID
5 and RAID 1 volumes.
shutdown and reboot, the
NAS appliance cannot tell
whether one or more
write failures occurred.
Therefore, following the
reboot, the NAS appliance
does a rebuild on all
volumes and regenerates
parity to make sure the
files are consistent.
functioning as designed.
I inserted four new hard drives in the NAS
appliance, and then reinstalled the operating
system. The NAS appliance is up and running,
and the LEDs are showing activity on the system.
However, the NAS appliance does not display in
the Kick-Start utility window.
The last step of the
reinstallation process is to
create the recovery
partition and the data
volume as RAID 5. The
system does not display in
the Kick-Start utility
window until the RAID 5
synchronization is
complete.
Wait until the RAID 5 synchronization is
complete. You can check the current
status of the RAID 5 synchronization by
using the NAS Manager. On the NAS
Manager primary menu, click Disks.
I cannot connect to or ping the NAS appliance
after turning it on.
Hard drives 0 and 1 have
failed or the operating
system files or boot
record are missing or
corrupt.
Use one of two resolutions:
Swap hard disks 0 and 1 with
hard disks 2 and 3. When your
NAS appliance is running, follow
the steps in "
" in the
"
" section.
Connect a client system to the
NAS appliance using a null-
modem cable. Reboot the NAS
appliance, press
select 2 Factory Default
Settings from the menu. After
the NAS appliance is running,
follow the steps in "
" in the "
" section.
After performing the steps in one of the two
procedures in the previous troubleshooting issue
that are required to re-establish the recovery
operating system, I still cannot connect to or
ping the NAS appliance.
Your hard drive main and
recovery mirrors are not
usable.
Perform the steps in "
PowerVault 715N Operating System
" in
the "
" section. If you have a
backup of your data, restore it. If a
backup is not available but your data
was in a RAID 5 configuration, follow the
steps in "
Reinstalling the Operating System
" in
the "
" section.
After using Terminal Services to connect to my
NAS appliance, I am unable to type using my
native language.
The NAS appliance is set
to English, the default
language.
You can install your native language
character set from the Multilingual
Support CD that was shipped with your
system. For installation instructions, see
"
I cannot get console redirection to work
correctly. Only a few keys work on the keyboard
and none of the keys work when trying to
configure the BIOS.
set on your keyboard.
Ensure the
off on the keyboard.
I cannot change the WINS addresses when I
click Network on the NAS Manager primary
menu, click Network Interfaces, and then click
WINS in the Tasks list.
The NAS Manager grays
out the WINS Servers
Configuration page
unless you set the IP
Address Configuration
page to Use the
following IP settings.
To set the WINS addresses from the
NAS Manager, click Network on the
primary menu, click Interfaces, click IP
in the Tasks list. On the IP Address
Configuration page, click the radio
button for Use the following IP
settings, and then type the IP
address, Subnet mask, and the
Default gateway in the appropriate