Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 66)

4-20
4
Service Procedures
T O REMOVE THE USER INTERFACE BOARD
N OTE : The UIB is attached to a removable bracket. You do not need to remove the
bracket when removing or replacing the UIB.
1. Shut down and open the ColorPASS (see page 4-4 and page 4-5).
2. Remove the front panel from the chassis (see page 4-9).
3. Remove three of the four screws that secure the UIB to the media bracket.
4. While supporting the UIB, remove the fourth screw.
F IGURE 4-12 Removing/replacing the user interface board
5. Disconnect the UIB cable from the connector on the UIB.
Press outward on the connector levers on each side of the connector (see Figure 4-13),
and then detach the connector. Avoid pulling on the cable.
F IGURE 4-13 Detail of ribbon cable connector
6. Place the board in an antistatic bag.
Screws
(2 of 4)
UIB
UIB cable
Mounting post on bracket
(1 of 4)
Connector levers