Checking external connections – Canon COLORPASS-Z6000 PS-NX6000 User Manual

Page 109

5-3

Preliminary on-site checkout

Checking external connections

Before removing the side and front panel of the ColorPASS to check internal
components, first eliminate the most obvious sources of problems. Make sure that:

• All interface cables to the system are plugged into the proper connectors on the back

panel of the ColorPASS (see Figure 5-2).

• The power cable is plugged into the wall power outlet.

• The LED on the network connector is blinking to indicate network activity.

IGURE

5-2

Back panel of the ColorPASS

If all the connectors are properly in place and the power is on, proceed to the next stage
of troubleshooting.

USB ports (ES-1000)

Keyboard (option)

Not used

Power cable
connector

Monitor (option)

Serial port (ED-100)

Parallel port (dongle)

Mouse (option)

Copier interface board

Empty slot

10/100/1000BaseT