Acronis True Image 9.1 Server for Windows - User Guide User Manual
Page 85
Specifies the partition where the image file is stored (by letter or number). This option is
used with /filename:file_name. In this case the file name must be specified without drive
letter or root folder. For example:
/file_partition:D
/filename:"\1.tib”
/password:[password]
Specifies the password for the image file (if required).
/harddisk:[disk number]
Specifies the hard disks to restore by numbers.
/partition:[partition number]
Specifies the partitions to restore by numbers.
/target_harddisk:[disk number]
Specifies the hard disk number where the image will be restored.
/start:[start sector]
Sets the start sector for restoring a partition to the hard disk unallocated space.
/size:[partition size in sectors]
Sets the new partition size (in sectors).
/type:[active | primary | logical]
Sets the new partition type. By default (if this option is not defined) an active partition is
created on the first hard disk and logic partitions on other disks.
/target_partition:[partition number]
Specifies the target partition number for restoring a partition over the existing one. If the
option is not specified, the program assumes that the target partition number is the same as
the partition number specified with the /partition option.
/reboot
Reboots the server after the operation is completed.
/log:[file name]
Creates a log file of the current operation with the specified file name.
3. list
Displays the list of the available drives and partitions.
Options
/filename:[filename]
Lists the image file contents.
When listing image contents, partition numbers may not coincide with those in the
drives/partitions list, if the image does not contain all the disk partitions. For example, if the
image contains partitions 2-3 and 2-5, they will be listed as 2-1 and 2-2.
If the deploy /partition command cannot find a partition in the image by its physical
number (for example 2-5), use /partition:
/target_partition:
Copyright © Acronis, Inc., 2000-2006 85