Chapter 6. restoring the backup data, 1 restore under windows or boot from cd, 1 network settings in rescue mode – Acronis True Image 9.1 Server for Windows - User Guide User Manual

Page 39: 1 ne work settings in rescue mode

Chapter 6. Restoring the backup data

6.1 Restore under Windows or boot from CD?

As mentioned above (see

True Image Server for Windows can be run in several ways. We recommend that you first
try to restore data running Acronis True Image Server for Windows under Windows, because
this method provides more functionality. Boot from the bootable media or use the Startup
Recovery Manager (see

3.4 Acronis Startup Recovery Manager)

only if Windows does not

load.
The boot CD from which you loaded the program does not keep you from using other CDs
with backups. Acronis True Image Server for Windows is loaded entirely into RAM, so you
can remove the bootable CD to insert the archive disk.

Be careful! Disk letters in standalone Acronis True Image Server for Windows might

sometimes differ from the way Windows identifies drives. For example, the D: drive

identified in the standalone Acronis True Image Server for Windows might correspond to the

E: drive in Windows.

If a backup image is located on bootable media, you might have a choice of using Acronis

One-Click Restore. This operation always restores the entire physical disk. Therefore, if your

disk consists of several partitions, all of them must be included into the image. Any partitions

which are missing from the image will be lost. Please make sure that the image contains all

disk data or you do not need the partitions that are not imaged before using Acronis One-

Click Restore. For more information on Acronis One-Click Restore see Error! Reference
source not found..

6.1.1 Network settings in rescue mode

When booted from removable media, RIS server or by Startup Recovery Manager, Acronis
True Image Server for Windows may not detect the network. Such might be the case if there
is no DHCP server in your network or your computer address was not identified automatically
for some reason.
To enable connection, specify network settings manually in the window, available at Tools -
> Options -> Network adapters.