Acronis True Image 9.1 Server for Windows - User Guide - Manual (Page 83)

Chapter 14. Command-line mode and
scripting
Acronis True Image Server for Windows supports the command-line mode, as well as the
GUI mode, and can be used to execute XML scripts.
14.1 Working in the command-line mode
An administrator might need a console interface in some situations. Acronis True Image
Server for Windows supports this mode with TrueImageCmd.exe utility. The file is located
in a folder where Acronis True Image Server for Windows has been installed, by default it is
C:\Program Files\Acronis\TrueImageServer.
14.1.1 Supported commands
TrueImageCmd has the following format:
trueimagecmd /[command] /[option1] [option2]…
The following commands are supported (each command may be accompanied by additional
options):
1. create
Creates an image file with the specified file name. A full image is created by default. Use the
/incremental option to create an incremental image.
Options
/progress:[on | off]
Shows/hides the progress information (percent completed). It is shown by default.
/filename:[filename]
Sets the image file name.
/password:[password]
Protects an image with a password.
/net_user:[username]
Specifies a user name when creating an image on a network drive.
/net_password:[password]
Specifies a user password when creating an image on a network drive.
/harddisk:[disk number]
Specifies the hard disks to include into the image file by numbers. The list of available hard
disks is provided by the /list command. An image may contain data of more than one hard
disk. In that case, separate disk numbers by commas, e.g.:
/harddisk:1,3
/partition:[partition number]
Copyright © Acronis, Inc., 2000-2006 83