Acronis True Image 9.1 Server for Windows - User Guide - Manual (Page 19)

Network share drive
Floppy disk
CD drive
5. The machine reboots.
6. Windows takes control and initiates the usual first-start process.
The recovery procedure can proceed under Windows as well (for example, if the operating
system is loaded from the C: drive, the system partition of the other computer can be
restored from an image to the D: drive). In this case, the user prompt for driver search on
Network-Floppy-CD will not be issued. If a compatible driver cannot be found, Windows will
suggest to ignore it or cancel restoration.
3.7.2 Using Acronis Universal Restore in virtual environment
Virtual machine technologies provide a powerful tool to help accelerate the development,
testing, deployment and support of PC applications. Using Acronis True Image Server for
Windows with Acronis Universal Restore you can perform real-to-virtual and virtual-to-real
computer migration in the same way as with real systems.
If the virtual hard drive uses SCSI controller, you should provide appropriate drivers while
performing system restore to the virtual machine. For example, the widespread VMware
environment requires Buslogic or LSI logic drivers. Use drivers bundled with your virtual
machine software or download the latest drivers versions from the software manufacturer
website.
3.7.3 Hints on using Acronis Universal Restore
1. The system recovered by Acronis Universal Restore may not start if the partition structure
in the image or the target disk partitioning does not coincide with that of the source disk. As
a result, the loader, restored from the image, will point to the wrong partition and the
system will not boot or will malfunction.
Such might be the case if you:
- image not the entire source disk, but only the selected partitions
Keep in mind, that the source disk may have a hidden maintenance partition created by the
computer vendor. Therefore, if you check each partition for backup instead of checking the
disk, this hidden partition will not be included into the image.
- restore not the entire source disk, but only the selected partitions. In some cases,
especially if your system resides on other than the first partition, this can confuse the loader
and prevent the restored system from startup.
To avoid the problem, we recommend that you image and restore the entire system disk.
2. When migrating to RAID, be sure to provide an appropriate driver for the RAID controller,
otherwise a basic HDD driver will be installed.
3. Acronis Universal Restore option is not available when restoring dynamic disks and
volumes.
4. The Acronis Universal Restore option does not work if a computer is booted with Acronis
Startup Recovery Manager (using F11) or the backup image is located in Acronis Secure
Zone. This is because Acronis Startup Recovery Manager and Acronis Secure Zone are
primarily meant for instant data recovery on the same computer.
Copyright © Acronis, Inc., 2000-2006 19