Paper-handling problems exist, Print is skewed (crooked), More than one sheet feeds at one time – HP LaserJet 3015 User Manual
Page 92: Media curls when fed through device, For more information
Paper-handling problems exist
Use the tips in this section when the device experiences paper-handling problems.
Print is skewed (crooked)
Are the media guides adjusted properly?
Remove all media from the input tray, straighten the stack, and then load the media in the
input tray again. Adjust the media guides to the width and length of the media that you are
using and try printing again. See
information.
More than one sheet feeds at one time
Is the media input tray too full?
See the start guide for more information about loading media input trays.
Is the media wrinkled, folded, or damaged?
Make sure the media is not wrinkled, folded, or damaged. Try printing on media from a new or
different package.
Is the automatic document feeder (ADF) media lever set incorrectly?
Make sure the ADF media lever is set to the multiple-sheet setting (to the left).
Device does not pull media from the media input tray
Is the device in manual feed mode?
Try one of the following remedies:
●
If Manual feed appears on the device control panel display, press
MENU
/
ENTER
to print the
job.
●
Make sure that the device is not in manual feed mode and print your job again.
Is the pickup roller dirty or damaged?
Contact a local HP authorized service provider. See
for instructions.
Media curls when fed through device
See
for more information.
82
Chapter 8 Troubleshooting
ENWW