Curl or wave, Wrinkles or creases, Curl or wave wrinkles or creases – HP LaserJet 3015 User Manual

Page 104: For more

Curl or wave

●

Check the media type and quality. Both high temperature and humidity can cause media
to curl. See

for more information.

●

The media might have been in the input tray for a long time. Turn over the stack of media
in the input tray. Also, try rotating the media 180° in the input tray.

●

The fuser temperature might be too high. See

Optimizing print quality for media types

for

instructions. This feature is also available in the HP toolbox.

You can also adjust the fuser temperature using the device control panel. The Less paper
curl setting in the Service menu sets the fuser temperature to the lowest setting. The
factory-set default is Off. Use the following instructions to turn this setting on.

1. On the device control panel, press

ENTER

2. Use the

or the

button to select Service, and then press

ENTER

3. Use the

or the

button to select Less paper curl, and then press

ENTER

Wrinkles or creases

●

Make sure that the media is loaded properly. See the start guide for information about
loading input trays.

●

Check the media type and quality. See

Device media specifications

for more information.

●

Turn over the stack of media in the tray. Also, try rotating the media 180° in the input tray.

Chapter 8 Troubleshooting

ENWW