Adjusting the lighter/darker (contrast) setting, To adjust the default lighter/darker setting – HP LaserJet 3015 User Manual

Page 58

Adjusting the lighter/darker (contrast) setting

The lighter/darker setting affects the lightness or darkness (contrast) of the copy. Use the
following procedure to change the contrast for the current copy job only.

To adjust the lighter/darker setting for the current job

1. On the device control panel, press

LIGHTER

DARKER

to see the current contrast setting.

2. Use the

or the

button to adjust the setting. Move the slider to the left to make the copy

lighter than the original, or move the slider to the right to make the copy darker than the
original.

3. Press

START

COPY

to save the selection and immediately start the copy job, or press

ENTER

to save the selection without starting the job.

Note

The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control panel display.

To adjust the default lighter/darker setting

1. On the device control panel, press

ENTER

2. Use the

or the

button to select Copy setup, and then press

ENTER

3. Use the

or the

button to select Def. Light/Dark, and then press

ENTER

4. Use the

or the

button to adjust the setting. Move the slider to the left to make all of the

copies lighter than the original, or move the slider to the right to make all of the copies
darker than the original.

5. Press

ENTER

to save the selection.

Chapter 4 Copying

ENWW