HP LaserJet 3015 - Manual (Page 54)

Loading originals to copy
Use these instructions to load originals into your device for copying. See Selecting media for
the automatic document feeder (ADF) for information about choosing original documents for
copying.
To load originals into the automatic document feeder (ADF)
input tray
Note ADF capacity is up to 30 sheets of 75 g/m 2 (20 lb) media (depending on the thickness of the
media), or until the ADF input tray is full.
The minimum size for media in the ADF is 74 by 105 mm ( (2.9 by 4.1 inches)). The maximum
size for media in the ADF is 215 by 356 mm ( (8.5 by 14 inches)). The ADF output bin holds
one sheet of legal-size media (215 by 356 mm (8.5 by 14 inches)). Subsequent sheets of
legal-size media slide off of the ADF output bin.
1. Adjust the ADF media lever, if necessary.
Note Move the ADF media lever to the right (single-sheet setting) if you are printing on a single
sheet of thick media.
2. Load the stack of originals to be copied into the automatic document feeder (ADF) with
media stack face-down and the first page to be copied at the bottom of the stack.
3. Slide the media stack into the ADF until the media does not move any farther. You might
have to tap the stack into the ADF.
44 Chapter 4 Copying ENWW