Changing the default copy-collation setting, To change the default copy-collation setting – HP LaserJet 3015 User Manual

Page 62

Changing the default copy-collation setting

You can set the device to automatically collate multiple copies into sets. For example, if you
are making two copies of three pages and the automatic collation is on, the pages print in this
order: 1,2,3,1,2,3. If automatic collation is off, the pages print in this order: 1,1,2,2,3,3.

To use the automatic collation, the original document must fit into the memory. If it does not,
the device makes only one copy and a message appears notifying you of the change. If that
happens, use one of the following methods to finish the job:

●

Split the job into smaller jobs that contain fewer pages.

●

Make only one copy of the document at a time.

●

Turn off the automatic collation.

●

If using the Best Photo quality setting, try using the Photo setting instead.

The collation setting you select is in effect for all copies until you change the setting.

The collation setting can also be changed from the device software. For instructions about
changing settings from the device software, see

Changing print settings

To change the default copy-collation setting

1. On the device control panel, press

ENTER

2. Use the

or the

button to select Copy setup, and then press

ENTER

3. Press

ENTER

to select Def. Collation.

4. Use the

or the

button to select On or Off.

5. Press

ENTER

to save your selection.

Note

The factory-set default for automatic copy collation is On.

Chapter 4 Copying

ENWW