Carrier Access BROADway System 770-0125-AB - Manual (Page 82)

3-34 BROADway - Release 4.00
Configuration
Upgrading System Software
TL1 Software Upgrade Commands
To display the version of system software running on your BROADway, use the RTRV-SW-VER TL1
command:
RTRV-SW-VER:::1234::ALL;
—NSP-1, NSP-2, or NSP (for both NSPs).
Examples:
Display the BROADway software version loaded on NSP-1:
RTRV-SW-VER::NSP-1:1234::;
Display the BROADway software version number loaded on both NSPs:
RTRV-SW-VER::NSP:1234::ALL;
To change the executable system software image on the BROADway system, use the SET-UPGRADE
TL1 command:
SET-UPGRADE:::1234::,ALL;
—NSP-1, NSP-2, or NSP (for both NSPs).
—The name of the new system software image file.
Examples:
Load the BROADway software on NSP-1 with the file bw308 (Release 3.08):
SET-UPGRADE::NSP-1:1234::bw308;
Load the BROADway software on both NSPs with the file bw308 (Release 3.08):
SET-UPGRADE::NSP:1234::bw308,ALL;
CAUTION! T HE SET-UPGRADE COMMAND CAUSES THE SYSTEM TO AUTOMATICALLY
REBOOT FROM THE SOFTWARE IMAGE SPECIFIED IN THE COMMAND LINE . T HIS IMAGE MUST
HAVE PREVIOUSLY BEEN DOWNLOADED USING FTP TO THE FLASH MEMORY ON THE
BROAD WAY SYSTEM . SET-UPGRADE AUTOMATICALLY UNZIPS THE SOFTWARE IMAGE INTO
THE EXECUTABLE APPLICATION FILES THAT THE BROAD WAY SYSTEM WILL USE TO OPERATE .