Carrier Access BROADway System 770-0125-AB - Manual (Page 56)

3-8 BROADway - Release 4.00
Configuration
Management Access to the BROADway System
Ethernet Port Command Line Access
1. Connect your PC or workstation to one of the Ethernet ports (see Cabling the Ethernet Port on
page 2-9) and open a Telnet session to the IP address of the BROADway system (e.g.
169.254.0.1).
2. You should be presented with the LOGIN> prompt. Use CUSTOMER for the user name and
BROADWAY as the password.
3. If you are successfully logged in, you will be presented with the NSP1> or NSP2> prompt.
4. You can now configure the BROADway system using the CLI interface. Follow the instructions
in Logging In With the Command Line Interface (CLI) on page 3-13 to learn how to log in and
out of the system using the CLI or in Setting Up User Accounts on page 3-13.
NOTE: The BROADway system supports up to three simultaneous Telnet client
sessions.
Ethernet Port Web Browser GUI Access
Connect your PC or workstation to one of the Ethernet ports on the BROADway and then follow the
instructions found at Logging In With the Web Browser Interface (GUI) on page 3-9.