Great Plains NTA3007HD Operator Manual - Manual (Page 74)

70 NTA907HD or NTA3007HD
166-207M 04/04/2011
Storage
Store the drill where children do not play. If possible,
store inside for longer life.
1. Unload all material in hoppers. See “Unloading
Materials” on page 65.
2. Unlatch the hopper lids so that the seals are not in
compression during storage. Route a chain or secu-
rity cable through the hold-down U-bolt and the latch
handle to prevent unauthorized entry, and prevent
high winds from opening the lid.
3. Empty the hoppers completely. Hand crank the
meters several turns to empty completely. See “Cali-
bration Crank” on page 57. Blow out the meters
with air to remove all material.
4. Unless cleaned out at last loading or during unload
above, deploy the auger, and run the motor in
reverse until auger is completely empty. See “Auger
Operations (Option)” on page 48
5. Return the auger to its cradle with the hopper in the
extended storage orientation. See “Storing Auger”
on page 53.
6. If equipped with optional air/hydraulic brake system,
drain water from reservoir (page 120).
7. Remove the drive chains and store in oil.
8. Lubricate the drill at all points listed under “Lubrica-
tion” on page 133.
9. Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
10. Check all moving parts for wear or damage. Make
notes of any parts needing repair or replacement
before the next season.
11. Open the meter-box doors completely to release
seal pressure and allow rinse water to exit.
12. Thoroughly wash the hoppers with water to prevent
corrosion from fertilizer or seed treatments.
13. Set doors to slightly open, but not wide enough for
animals to enter the meters. Wire doors in place if
needed. Do not store the drill with seals com-
pressed.
14. Raise and stow the ladder, to discourage climbers.
15. Lubricate all points listed in Maintenance to prevent
rust.
16. Clean air drill of mud, dirt, excess oil and grease.
17. Grease exposed cylinder rods to prevent rust.
18. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
MetaData: End of Operating Instructions