Great Plains NTA3007HD Operator Manual - Manual (Page 31)

Operating Instructions 27
04/04/2011 166-207M
Refer to Figure 17
7.
Observe wings and gauge wheels lowering during
unhook.
Null4:
8. When cylinder is fully retracted, set circuit to Neutral.
Null4:
Unfolding: Release Transport Locks
Refer to Figure 18 (shown after tilt-down and unfold for clar-
ity - these lock changes must be performed prior to tilt-down
and unfold)
At wing tip
,and side of mainframe , on each side
(4 locations total), reconfigure the locks from:
ROAD to FIELD
Decals at each lock, and the illustrations on the next
page, depict the handle operations.
Note: The mid-wing locks reset to FIELD automatically
during tilt-up, and do not require changes.
Null4:
Free Wing Transport Locks
9.
Relieve any weight on the wing tip locks.
Select Tilt operation:
Briefly perform a tilt-up.
Null4:
Null4:
Figure 17
Wing Movement During Unhook
29389
Null4:
Unhook: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral Neutral Neutral Neutral
Null4:
Figure 18
Transport Lock Locations
29423
1
2
3
1 3
2
Null4:
Figure 19
CFM Tilt Enable for Un-Weight
29380
Tilt Un-Weight: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral Neutral
Retract
then
Neutral
Neutral