Great Plains NP30A 30-foot Operator Manual - Manual (Page 47)

2014-05-20 Table of Contents Index 407-502M
Great Plains Manufacturing, Inc. Table of Contents Index 43
Applicator Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity, and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the
Nutri-Pro
®
fertilizer applicator to the field.
This checklist presumes that the nurse tank is not yet
connected.
❑ Carefully read “Important Safety Information” on
page 1.
❑ Empty the applicator’s 5 gallon wash water tank,
Refill it with fresh clean water.
❑ Review the Material Safety Data Sheet (MSDS) for
the anhydrous ammonia.
❑ Check that all time-dated applicator components are
still within their specified service lives.
❑ Check all plumbing components, hose, tubing and
fittings are in satisfactory working condition.
❑ Lubricate fertilizer applicator as indicated under
“Lubrication and Scheduled Maintenance” on
page 126.
❑ Check all tires for proper inflation. See “Tire
Inflation Chart” on page 139.
❑ Check all bolts, pins, and fasteners. Torque as
shown in “Torque Values Chart” on page 139.
❑ Check fertilizer applicator for worn or damaged
parts. Repair or replace parts before going to the
field.
❑ Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.
High Pressure Fluid Hazard:
Relieve pressure and shut down tractor before connecting,
disconnecting or checking hydraulic lines. Use a piece of
paper or cardboard, NOT BODY PARTS, to check for leaks.
Wear protective gloves and safety glasses or goggles when
working with hydraulic systems. Escaping fluid under pressure
can have sufficient pressure to penetrate the skin causing
serious injury. If an accident occurs, seek immediate medical
assistance from a physician familiar with this type of injury.