Great Plains NP30A 30-foot Operator Manual - Manual (Page 12)

8 NP30A or NP40A Table of Contents Index Great Plains Manufacturing, Inc.
407-502M Table of Contents Index 2014-05-20
Safety Decals
Safety Reflectors and Decals
Your applicator comes equipped with all safety reflectors
and decals in place. They were designed to help you
safely operate your applicator.
▲ Read and follow decal directions.
▲ Keep all safety decals clean and legible.
▲ Replace all damaged or missing decals. Order new decals
from your Great Plains dealer. Refer to this section for
proper decal placement.
▲ When ordering new parts or components, also request
corresponding safety decals.
To install new decals:
1. Clean the area on which the decal is to be placed.
2. Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
818-055C
Slow Moving Vehicle Reflector
On a mount attached to the transport rest assembly;
1 total
31601
838-266C
Red Reflectors
On the rear face light bracket, and
back face, outside ends of the top transport rest tube;
4 total
31601
838-265C
Amber Reflectors
On front face of front tool bar near wing hinge;
2-Point and Pull-Type models:
On the outside faces of casters (2-point, pull-type);
3-Point Models:
on the outside faces of lift assist brace weldments;
4 or 6 total
31601