Great Plains NTA3510 Installation Instructions - Manual (Page 20)

Great Plains Mfg., Inc.
20 Blockage Monitor Kits
168-414M 10/29/2008
NTA30: Install WSMB Harnesses
Start with Tower 1 (left wing, left tower)
Refer to Figure 43
22. Select one:
467981201 INT AG HARNESS, WSMB MODULE
Join the row harness connector to the mating
connector on the row harness .
Plug the WSMB connectors into the WSMB .
These connectors are not interchangeable, and are
keyed to ensure correct insertion.
Refer to Figure 41 on page 19
23. Select two:
800-082C CABLE TIE .31X21.5 6DIA 120LB
Coil up excess row harness leads and tie the bundle
to the tower, above and below the lower U-bolt.
24. Repeat step 22 and step 23 for each tower.
Refer to Figure 44, 45 and Figure 46 on page 21
25. Select one new:
467980140 DJ 20’ HARNESS EXT
26. At the front center of the drill, locate the existing
implement WSMB:
467982000S1 PLNTR CNTRL OUTPUT MODULE(POM)
At the WSMB connectors, follow harness:
467983502 DJ 2SOL YP24LIFT/HITCH FCM HRN
Locate the CAN bus terminator:
467980126 MINI CAN TERMINATOR
27. Remove and save the terminator .
Connect the 20ft harness extension in its place
(two connectors).
Refer to Figure 45 and Figure 46 on page 21
28. At Tower 4, plug the saved CAN bus terminator
into the WSMB harness .
Figure 43: NTA30:
WSMB Harness
28200
40
1
2
31
30
40
39
3
4
5
U
D
L R
40
1
31
2 39
13
Figure 44: NTA30:
Existing WSMB Location
28438
97
97
98
34
97
98
91
Figure 45: NTA30:
CAN Terminator
28429
98
91
98
91
34
91
40