Great Plains YP3025A Operator Manual - Manual (Page 127)

Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 123
02/16/2012 Table of Contents Index 401-705M
Caster Stabilizers
One UHMW brake piston each caster;
2 total.
Replace UHMW piston if its length is less than 3.2cm
(1
1 ⁄
4
in). Also replace piston if missing, damaged, tilted,
or top of piston is visible. Measuring the length requires
at least partial disassembly of the caster pivot, and is not
recommended unless there are indications that the pis-
ton might need replacement.
To set spring tension with a new piston:
a. Loosen jam nut
and back out set screw .
b. Drive screw in (down) until it contacts spring plate .
c. Drive screw in another 1 inch (2.5cm).
d. Tighten jam nut.
Use more tension as needed to eliminate caster vibration
during highway transport.
Null4:
Wing Casters: Wheel Hubs
4 bearings; 2 each wing
Type of Lubrication: Grease
Quantity: Re-pack
Null4:
Markers: Disk Hub
4 bearings; 2 each marker
Type of Lubrication: Grease
Quantity: Re-pack
Null4:
Seasonal
Null4:
31470
Null4:
1
4
3
2
1
2 3
4
Seasonal
Null4:
31368
Seasonal
Null4:
25018