Cabletron Systems ELS10-26 - Manual (Page 130)

6-18
ELS10-26 MIB
lxifTxStormTime {lxifEntry 9}
Time Ticks Read-Write
The period of time, in centiseconds, which qualifies sifTxStormCnt
(not applicable for the UART port).
llxifFunction {lxifEntry 16}
Integer Read-Only
The current functional state (protocols which have been activated
and are operational) of the port. The following values or
combinations thereof are supported:
0x0001 NMS - the port may be used for communicating with
the NMS (see ifOperStatus).
0x0002 TBRIDGE - use the port for Transparent IEEE 802.1d
bridging (see lxsprotoBridge).
0x0020 NO_BPDU - if TBRIDGE is set, this disables the
sending of BPDUs (see lxsprotoSuppressBpdu) and
keeps the port in forwarding state (this is to provide
interoperability with non-compliant IEEE 802.1d
implementations; however, if the physical topology
has any loops, then LAN segments will most likely be
flooded with duplicates of packets).
0x0040 RIP_LISTENER - use RIP on the port for IP Routing
(see sprotoRip).
0x0800 ARP - use the port for resolving ARP.
0x10000 TRUNKING - use the port for Trunking Protocol.
These values can be configured through the lxsprotoTable.
lxifRxHwFCSs {lxifEntry 18}
Counter Read-Only
Number of received packets discarded due to FCS errors.