beautypg.com

5 addresses configuration group, Addresses configuration group -13 – Cabletron Systems ELS10-26 User Manual

Page 125

background image

ELS10-26 MIB

6-13

6.1.5 Addresses Configuration Group

The Addresses Configuration Group consists of the parameters
described below.

lxaddrStatics

{lxaddr 1}

Counter Read-Only

The number of static addresses which are currently stored in the
ELS10-26.

lxaddrDynamics

{lxaddr 2}

Counter Read-Only

The number of learned addresses in the ELS10-26’s address table.

lxaddrDynamicMax

{lxaddr 3}

Gauge Read-Write

The maximum number of spanning tree addresses which have
been learned since the ELS10-26 was last booted (or this parameter
was last reset by the NMS).

lxaddrDynamicOverflows

{lxaddr 4}

Counter Read-Write

The number times an address was not learned due to insufficient
address table space.

lxaddrFlags

{lxaddr 5}

Integer Read-Write

Flags to describe the use and control of this address entry. Each bit
has a different meaning. The NMS must always set either
entry-static or entry-none; however, for GetRequests, the NMS will
see either no bits set (if the entry does not exist), or exactly one of
the following bits set:

• bit 29 is reserved.

• entry-static = 28, if set then this is a pre-defined customer

address, e.g., an IEEE Spanning Tree static address.