Great Plains YP1630F-1670 Operator Manual - Manual (Page 24)

20 YP1630F Table of Contents Index Great Plains Manufacturing, Inc.
401-832M Table of Contents Index 2012-12-27
Electrical Hookup
Refer to Figure 6 (depicting an SAE J560b lighting
connector; your connector may vary if it has been replaced
due to different electrical conventions)
Your planter is equipped with systems that require
separate electrical connections. For future reference,
note any optional connectors on this checklist.
❑
Lighting connector (standard)
❑
Monitor connector (standard, See page 120 for
console installation.)
❑
Speed Sensor connector (standard)
❑ __________________________
Make sure tractor is shut down with accessory power off
before making connections.
Store Main Parking Stand
Refer to Figure 7
13. Raise the 3-point hitch slightly.
14. Remove the lower pin holding the parking
stand . Swing the parking stand back and up until it
is above the rear hole . Place the holding pin in the
rear hole and allow the parking stand to rest on it.
This is the transport position for the parking stand.
15. Adjust the top link of a 3-point long enough so the
ball swivel does not bottom out when fully raised.
16. Secure hoses using hose post loops (not shown) so
that hoses have ample slack for lifts and turns, but
cannot get caught in tongue lock or ball swivel.
Failure to do so could cause hose to be crushed
requiring hose replacement.
Figure 6
Connector Identification
25236
31033
31950
a
b
c
a
b
c
Figure 7
Storing Parking Stand
22813
5
6
7
5
7
6