Great Plains NTA2007 Operator Manual - Manual (Page 78)

74 NTA607 or NTA2007 Table of Contents Index Great Plains Manufacturing, Inc.
166-372M Table of Contents Index 2012-01-05
Actuator Channel Setup
1.
Assign material.
2. Type must be set to GRAN SEED CONTROL or
GRAN FERT CONTROL.
3. Check that other setting are as Required, and reflect
the actual configuration of the implement.
Calibrate
Variable Rate kit calibrate begins on page 83.
Example Channel Setup:
Parameter Value Comment
CHANNEL 1 or 2
Per meter
being
configured
Type
GRAN SEED CONTROL
or
GRAN FERT CONTROL
One of these
Required
Material
Name
Wheat HRW
or
11-52-0 Example
user-specified
names
Control
Mode
Auto Required
Drive Type Zero Max 1 or 2 Required
Drive Freq. 40 Hz Required
Input Filter 50 % Required
Sensor
Constant
360 PUL/REV Required
Gear Ratio 1.0 Required
Meter Gear
Range
LOW or HIGH
One of these
Required
# Seed
Rows 32, 36, 40, 48, 50, 60, 65,
66, 80
read-only, per
implement or
drill model
Channel
Width
(set to swath of
implement or drill, in cm
or inches)
Required
Flush
Enable
Disabled Data not used
Precharge(+)
\Delay(-)
0.0 SEC Data not used