Great Plains NTA2007 Operator Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Table of Contents Index Important Safety Information 9
2012-01-05 Table of Contents Index 166-372M
Practice Safe Maintenance
▲ Understand procedure before doing work. Use proper
tools and equipment. Refer to this manual. For brake
work, see specific safety information beginning on
page 123.
▲ Work in a clean, dry area.
▲ Unfold and lower the drill, put tractor in park, turn off
engine, and remove key before performing maintenance. If
work must be performed with implement raised, use centre
section lift lock and gauge lock channels provided.
▲ Make sure all moving parts have stopped and all system
pressure is relieved.
▲ Allow drill to cool completely.
▲ Disconnect battery ground cable (-) before servicing or
adjusting electrical systems.
▲ Welding: Disconnect battery ground. Protect hydraulic
lines. Avoid fumes from heated paint.
▲ Inspect all parts. Make sure parts are in good condition
and installed properly.
▲ Remove buildup of grease, oil or debris.
▲ Remove all tools and unused parts from drill before
operation.
Safety At All Times
Thoroughly read and understand the instructions in this
manual before operation. Read all instructions noted on
the safety decals.
▲ Be familiar with all drill functions.
▲ Operate machinery from the driver’s seat only.
▲ Do not leave drill unattended with tractor engine running.
▲ Do not stand between the tractor and drill during hitching.
▲ Keep hands, feet and clothing away from power-driven
parts.
▲ Wear snug-fitting clothing to avoid entanglement with
moving parts.
▲ Watch out for wires, trees, etc., when folding and raising
drill. Make sure all persons are clear of working area.