Preparation and setup, Initial setup, Seasonal setup – Great Plains NTA2007 Operator Manual User Manual

Page 29: Pre-planting setup

2012-01-05

Table of Contents

Index

166-372M

Great Plains Manufacturing, Inc.

Table of Contents

Index

Preparation and Setup

This section helps you prepare your tractor and NTA607
or NTA2007 for use, and covers seasonal tasks, and
tasks when the tractor/drill configuration changes.

Before using the NTA607 or NTA2007 in the field, you
must hitch the drill to a suitable tractor, inspect systems
and level the drill. Before using the drill for the first time,
and periodically thereafter, certain adjustments and
calibrations are required.

Initial Setup

See “Appendix B - Initial Setup” on page 167 and
“Appendix C - Option Installation” on page 168 for
pre-delivery items (normally completed by dealer), and
first-time/infrequent setup tasks, including:
❑ Install seed monitor console in tractor (page 167).
❑ Remove protective film from large highway

reflectors.

❑ Set marker extension (page 100) and speed.

Seasonal Setup

On initial delivery, use with a new tractor, and seasonally,
check and as necessary, complete these items before
continuing to the routine setup items:
❑ Bleed hydraulic system (page 119).
❑ Wing levelling and alignment (page 133).
❑ Speed sensor calibration (DICKEY-john

Air Cart

Control manual).

❑ Blow out entire air system to remove condensation.

Check air flow at each row, for evidence of plugging.

❑ De-grease exposed cylinder rods if so protected at

last storage.

Pre-Planting Setup

Complete this checklist before routine setup:
❑ Read and understand “Important Safety

Information” on page 5.

❑ Check that all working parts are moving freely, bolts

are tight, and cotter pins are spread.

❑ Check that all grease fittings are in place and