Storage, Unfolded storage – Great Plains NTA2007 Operator Manual User Manual
Page 71
Great Plains Manufacturing, Inc.
Operating Instructions
67
2012-01-05
166-372M
Storage
Store the drill where children do not play. If possible,
store inside for longer life.
1.
Unload all material in hoppers. See “Unloading
Materials” on page 113.
2.
Raise, fold and lock implement (page 39 and
page 35). For unfolded storage, see steps at right.
3.
Un-latch the hopper lids so that the seals are not in
compression during storage. Route a chain or
security cable through the hold-down U-bolt and the
latch handle to prevent unauthorized entry, and
prevent high winds from opening the lid.
4.
Empty the hoppers completely. Hand crank the
meters several turns to empty completely. See
“Calibration Crank, Bag and Scale” on page 56.
Blow out the meters with air to remove all material.
5.
Perform Parking checklist (page 66), except for
step 3.
6.
If equipped with optional air/hydraulic brake system,
drain water from reservoir (page 125).
7.
Remove the drive chains and store in oil.
8.
Lubricate the drill at all points listed under
“Lubrication and Scheduled Maintenance” on
page 136.
9.
Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
10. Check all moving parts for wear or damage. Make
notes of any parts needing repair or replacement
before the next season.
11. Open the meter-box doors completely to release
seal pressure and allow rinse water to exit.
12. Thoroughly wash the hoppers with water to prevent
corrosion from fertilizer or seed treatments.
13. Set doors to slightly open, but not wide enough for
animals to enter the meters. Wire doors in place if
needed. Do not store the drill with seals
compressed.
14. Raise and latch the ladders, to discourage climbers.
15. Lubricate all points listed in Maintenance to prevent
rust.
16. Clean drill of mud, dirt, excess oil and grease.
17. Grease exposed cylinder rods to prevent rust.
18. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
Unfolded Storage
See page 110 for details on maintenance lock.
2a. Raise and unfold implement.
2b. Install gauge wheel lock channels.
2c. Initiate a fold, just until centre lock engages.
2d. Lower implement onto lock channels.
2e. Set all hydraulic remotes to Float.