SARGENT Profile Series v.G1.5 Mortise Locks - Manual (Page 11)

6.8 – Hardwiring Options
NOTE: IF HARDWIRING IS NOT REQUIRED, THEN GO TO STEP #6.9
Hardwiring options include one or a combination of the following: Forced/Propped Door and/or Hard Power
6.8.A. – Important
1. Caution: Disconnect all input power before beginning installation to prevent electrical shock and
equipment damage
2. Installer must be a trained, experienced service person
3. All wiring must comply with applicable local electrical codes, ordinances and regulations
6.8.B. – Installation Notes
1. With new applications, an ElectroLynx door harness with 8 and 4 pin connectors will be pre-installed
inside door by ASSA ABLOY door manufacturer when specified during ordering process
2. Wiring to pigtail harness is per facility wiring requirement. ElectroLynx connector terminations and wire
colors all match
3. If door does not have an ElectroLynx type door harness, cut connectors off product and hardwire, or
consult factory for appropriate mating harness
6.8.C – ElectroLynx Connector System
The system is designed to be installation friendly with pluggable connectors
from the electric hinge through the door to the rail. The only wiring required is
to the loose wires on the pigtail harness assembly on the frame side of the
electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to mate and lock together
as shown in the figure. Plug the connectors into each other with the locking
mechanism aligned as indicated.
Do NOT force connectors on any other way.
Locking mechanism
Plug
Receptacle
Profile Series v.G1.5 Mortise Dorm Lock
As part of their promise to provide innovative, fast
and effective, and higher security solutions to their
customers, ASSA ABLOY Group companies offer
ElectroLynx, a universal quick-connect system that
simplifies the electrification of the door opening.
ElectroLynx™ is a trademark of ASSA ABLOY, Inc.
9
© SARGENT Manufacturing Company 2006, 2007
For installation assistance, contact SARGENT at 800-810-WIRE (9473)