SARGENT 7 Line - Manual

7 & 10 LINE LOCKS INSTALLATION
INSTRUCTIONS
(CYLINDERS BY OTHERS) 30- PREFIX
1
2
FOLLOW DIRECTIONS A - G AND I ON INSTRUCTION SHEETS A7133 10 LINE
STANDARD & A7240 7 LINE STANDARD.
INSTALLING LEVERS
1. LOCKSET SHOULD BE ASSEMBLED AND SECURED TO DOOR AS
PER INSTRUCTION SHEET SHOWN ABOVE.
2. PLACE SCALP COVER ON INSIDE ROSE (SIDE WITH EXPOSED SCREWS)
ALIGNING DIMPLES WITH RECESSES IN THE INSIDE ROSE AND TURN
CLOCKWISE TO LOCK.
3. ASSEMBLE INSIDE LEVER (USUALLY BLANK OR PUSH BUTTON LEVER)
ON LOCKSET BY SLIDING LEVER ONTO TUBE. MAKE CERTAIN LEVER
CATCH ON TUBE IN ENGAGED IN LEVER.
4. ASSEMBLE OUTSIDE LEVER AS FOLLOWS:
INSERT CYLINDER INTO OUTSIDE LEVER. PRESS RETAINER INTO
LEVER. SLIDE ONE WASHER OR TWO, AS NEEDED, ONTO TAILPIECE
OF CYLINDER. (SEE FIGURE 1)
5. SLIDE OUTSIDE LEVER ASSEMBLY ONTO TUBE AS FAR AS IT WILL GO.
TURN KEY 45° CLOCKWISE. PUSH LEVER AGAIN, UNTIL LEVER CATCH
IS ENGAGED, SECURING THE LEVER.
NOTE: SEE SPECIAL INSTRUCTIONS FOR 16, 30, 37 AND 54 FUNCTIONS ON
INSTRUCTION SHEET A7133 AND A7240.
NOTE:
CYLINDER TAIL PIECE
MUST BE ORIENTED
AS SHOWN.
7 LINE CYLINDER
RETAINER
10 LINE CYLINDER
RETAINER
CYLINDER
WASHERS
OUTSIDE
LEVER
KEY
FIGURE 1
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A6838D