SARGENT 7800 Knob Locks - Manual

6, 8 And 9 line locks should be assembled and have
outside knobs locked (by inside knob push or turn button
— or previously by outside knob, key or construction
plug). Then insert control key into replacement core and
turn counterclockwise until stop is reached. Slide core
onto pins and into knob.
THE 11-6300 AND DG1-2-OR 3- 6300 CORES ARE ONLY COMPATIBLE WITH HARDWARE ORDERED
TO ACCEPT THEM, EXISTING HARDWARE MAY REQUIRE TO BE MODIFIED OR REQUIRE THE USE
OF NEW TAIL PIECES IN BORED LOCKS — SEE CATALOG FOR MORE INFORMATION
11-6300 CORES KEYED 1 BITTED USE A CONTROL KEY CUT 113511
BORED LOCKS
Insert control key and
turn counterclockwise
until stop is reached.
With key in this position, pull out core.
To remove key, return to vertical position and withdraw.
Insert control key and rotate
15 degrees counterclockwise
With key in this position, pull out core.
Insert correct tail piece in to
back of core and secure with
tail piece retainer as shown.
INSTRUCTIONS FOR THE REMOVAL AND INSERTION OF
SARGENT CONSTRUCTION CORES, 11-6300 and DG-6300
REMOVABLE CORE CYLINDERS
For assistance, contact SARGENT at 800-727-5477 or www.sargentlock.com
Copyright © SARGENT Manufacturing. All rights reserved. Reproduction in whole or in part without the express
written permission of SARGENT Manufacturing is prohibited.
C
New Cylinder
C
New Cylinder
C
To remove key, return to
vertical position and withdraw.
(Note: for easiest key removal
hold core in place while
starting to withdraw key.)
Note : if inside
knob button will
not lock knob,
rotate pins in
knob 180°.
Note : pins in knob should be positioned at
about a 15° angle to align with holes in core.
15°
RIM AND MORTISE CYLINDERS LEVER /BORED LOCKS
To remove key, return to
vertical position and withdraw.
(Note: for easiest key removal
hold core in place while
starting to withdraw key.)
Make sure that key
clearance slot faces
down.
With pins aligned in housing as shown below, with
control key in core rotate key counter clock wise
and insert core in to housing.
15°
Note: pins should be
positioned at about a 15°
angle to align with holes
in core.
To remove key, return to vertical position and withdraw. (Note: for easiest
key removal hold core in place while starting to withdraw key.)
REMOVING CORE FROM BORED LOCKS INSTALLING CORES IN BORED LOCKS
6, 8 And 9 line locksets should be
assembled and have outside knobs
locked (by inside knob push or turn
button — or by inside knob key).
Then insert control key and turn
counterclockwise until stop is reached.
With key in this position, pull out core.
To remove key — return to vertical
position and withdraw.
INSERTING CYLINDER CORE
CORE REMOVAL—RIM AND MORTISE CYLINDERS
To remove 60- plastic disposable core pull from lock, save and reuse tail piece in permanent core on bored locks
Install core and tail piece into lock
by inserting control key and rotating
counter clock wise then inserting
core into lock
A5634L