SARGENT 7 Line - Manual

CONTROL
KEY
1. Rotate bottom plug until notch lines up with indicator dot
on top plug.
2. Pull bottom plug straight out, then remove top plug.
Important- Save tail piece on back of construction plug to be
reused with cylinder.
REMOVING DISPOSABLE PLASTIC PLUGS
REMOVING CYLINDER CORE
INSERTING CYLINDER CORE
NOTE: Tail piece or pins version construction can be used
depending on lock. See reverse side for description.
1. Insert top plug into top hole in lever.
• If
pins version insert bottom plug with notch facing horizontal
on to pins.
• If
tail piece version insert the tail piece into the bottom plug
then insert bottom plug with notch facing horizontal into lever.
INSERT DISPOSABLE PLASTIC PLUGS
2
3
CYLINDER
WITH TAIL PIECE
1A
1. Insert control key
2. Turn clockwise until stop is reached
3. With key in this position–pull out core
4. To remove key–return to horizontal position
and withdraw
NOTE: If a control key is needed for one bitted removable core
(63-) cylinders, cut a key blank from bow to tip using 113511.
NOTE: Tail piece or pins version construction can be used
depending on lock. See reverse side for description.
1. A) Tail piece version - The tail piece should be inserted
into back of cylinder. (Use tail piece stamped “6” if 6 pin
cylinder and “7” if 7 pin cylinder.) See figure A
B) Pins version - Rotate the pins gently to 15 degrees
offset. See figure B.
2. Then insert control key into replacement core and insert
cylinder into lever
3. To remove key–return to horizontal position
and withdraw
1
NOTE:
For easier removal hold core in
place while starting to withdraw key.
INSTALLATION INSTRUCTIONS FOR
7 and 10 Line Levers with SARGENT Removable Core (63-)
or Arrow, Best and Falcon Interchangeable Core
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com
BOTTOM
PLUG
INDICATOR
DOT
NOTCH TOP PLUG
LEVER
TAIL PIECE
(6 OR 7 PIN)
LEVER
PINS
15°
PINS
TOP PLUG
BOTTOM
PLUG
FIGURE A FIGURE B
1B
PINS
VERSION
3
CORE
CONTROL
KEY
LEVER
2
A6847E
Copyright © 2012 SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.