beautypg.com

Unitec Wash Select II POS Installation Manual User Manual

Page 53

background image

W A S H

S E L E C T

I I

Document Number:

WS21001

47

Document Title:

Wash Select II POS Installation Manual

NOTE: You can do this only for the standard Canadian WSII (accepts all quarters, $1
and $2 coins, and tokens).

Remove the coin acceptor label that reads “Quarters, $1 & $2 coins, Tokens”

from the front of the door.

Replace the new label that reads “$1 coin, $2 coin, Token”.
Put unit in setup mode.
Go to Diagnostics main menu.
Go to the “Test bills/coins “ sub-menu.
Open the cover of the IDX acceptor.
Turn the rotary switch of the IDX to position 5.
Press the reset button to the left of the rotary switch only once.
Turn the rotary switch back to zero and close the IDX cover.
Insert quarters to the IDX and check if the quarter acceptance has been

erased from the IDX.

A. Programming the IDX to Accept Currency

The Canadian Wash Select II comes programmed to accept and dispense the
Canadian $1 dollar coin and quarter. If your unit needs to be reprogrammed for any
reason, use the following procedures.

To program the IDX acceptor, you will need to have six of each of the coins that you
are trying to program (coins or tokens).

1. If you are accepting old style $1 coins:

1. Remove the front cover by pushing in and up at the bottom right corner of

the main body of the unit (near the phone number printed on the cover).

2. Find the rotary-switch and set it to the position labeled number 5.

3. Press the reset button immediately to the left of the rotary switch once.

4. Drop the six different old style dollar coins through the acceptor. The IDX

will blink once after each coin. Verify that the light (LED) blinks 5 times
after the last coin is entered.

5. Replace the rotary switch back to zero.

2. If you are accepting new style $1 coins:

1.

Remove the front cover by pushing in and up at the bottom right corner of
the main body of the unit (near the phone number printed on the cover).

2.

Find the rotary-switch and set it to the position labeled number 4.

3.

Press the reset button immediately to the left of the rotary switch once.

4.

Drop the six different new style dollar coins through the acceptor. The IDX
will blink once after each coin. Verify that the light (LED) blinks 5 times
after the last coin is entered.

5.

Replace the rotary switch back to zero.

This manual is related to the following products: