Unitec Wash Select II POS Installation Manual - Manual (Page 13)

W A S H S E L E C T I I
Document Number: WS21001 7
Document Title: Wash Select II POS Installation Manual
2 Tools Required for Installation
2.1 Mechanical Installation Tools
It is highly recommended that the Wash Select II be bricked in! All attempts should be made
to achieve that end. It is ultimately the responsibility of individual distributors to make this
decision, and if the decision is made that it will not be possible, Unitec offers an optional base
at an affordable price. The following tools are recommended for the typical mechanical
installation of this Wash Select II unit and optional base:
6” inch or longer ratchet extension (for optional straight base)
¾” inch deep well socket and socket wrench
Open end 9/16” inch wrench
Small, thin blade, flat-tip screwdriver
Hammer drill
½” Concrete hammer drill bit
Hammer
Dual-plane Level
50’ foot tape measure
2.2 Electrical Installation Tools
In addition to the mechanical assembling of the Wash Select II unit to the base (and the entire
package to the concrete), there will be a number of electrical connections, which must be
made. These connections will require the use of the following common electrical tools:
Small, thin tipped, straight screwdriver (1/8” tip, for green Phoenix connectors)
Wire strippers (capable of handling 10-22 AWG wire)
Cable or wire tie wraps
Diagonal cutters
Needle nose pliers
Telephone wire crimping tool and 4-pin, RJ11 / 14 modular plugs (for modem, if
present) Radio Shack Part # 279-384