Unitec Wash Select II POS Installation Manual - Manual (Page 46)

W A S H S E L E C T I I
Document Number: WS21001 40
Document Title: Wash Select II POS Installation Manual
Appendix B. Recorded Speech Messages
Recording custom speech messages is accomplished by connecting the supplied
microphone into the Speech Module microphone plug located under the clear cover over the
CPU board. Speech programming is initiated by using the “Speech” menu in “Setup Mode”.
Directly underneath the CPU cover is a small, piggybacked circuit board with a black volume
control knob protruding straight out. This is called the “Speech Module. The volume output
from the speech module can be adjusted by depressing the black, square button to play
message1, and turning the control knob clockwise to increase, or counter-clockwise to
decrease the volume. The recording volume can also be adjusted by rotating the small,
circular, white, slotted dial, just to the right of the volume knob. For the loudest recording
volume, turn the dial counterclockwise. The 10 o’clock position tends to work best.
To record a message, place the unit into “Set-up Mode” and scroll through the list of menu
items until “Speech” is displayed on the main customer display. Then, depress the (*) button
on the keypad. Scroll until “Record Messages” is displayed and press the (*) button once
again. Place the microphone’s connector into the jack, located at the top of the speech
module, and enter the number of the message that you wish to re-record.
To playback the message that was just recorded, press the (3) button to scroll forward until
“Play Message” is displayed, and press the (*) key. Key in the appropriate message number,
followed by the (*) key, and the message will begin to play.
There are 2- red LEDs on the module: one for “Play”, and the other for "Record”. These will
illuminate during either the playback or record cycles as an indicator of the current status. At
the end of the message recording time, the “Record” LED will extinguish.
Here is the complete list of Wash Select II messages and scripts:
1) GREETING MESSAGE (10.25 seconds)
Hello, welcome to OUR Car wash. Please Select your wash or enter your code now.
2) SELECT PACKAGE (4.25 seconds)
Please select your wash package now.
3) PACKAGE 1-PURCHASED (8.5 seconds)
You have purchased the Express Wash. You may enter the wash if it is ready.
4) PACKAGE 2 PURCHASED (8.5 seconds)
You have purchased the Super Wash. You may enter the wash if it is ready.
5) PACKAGE 3 PURCHASED (8.5 seconds)
You have purchased the Deluxe Wash. You may enter the wash if it is ready.