Unitec Wash Select II POS Installation Manual - Manual (Page 42)

W A S H S E L E C T I I
Document Number: WS21001 36
Document Title: Wash Select II POS Installation Manual
2. Verify that every wash purchased gives the proper wash package at the car wash
side. Make any adjustments on relay output wires that may be required, and
verify that the Wash-In-Use signal resets the controller electronics.
3. Pull the car wash relays connector (J-17 on CPU), and proceed to purchase all of
the washes again, by using tokens, quarters, and a fleet account code. There is
no need to test the actual washes given; rather, just verify that the corresponding
relay closes, by simply viewing the status of the red LEDs located on the back of
the display board. Once this step is complete, replace the J-17 connector and
continue to step 4.
4. If you have connected to a POS4000, print out a code for each wash at the
POS4000 and try it at the Wash Select II
™.
5. Close and bolt the door, insert the locks and verify that the unit is secure. Using a
clean rag and a gentle soap, clean the box’s frame, door, and surrounding areas.