Unitec Wash Select II POS Installation Manual - Manual (Page 34)

W A S H S E L E C T I I
Document Number: WS21001- L 28
5 Startup / Programming
For the following sections, the Wash Select II unit must be powered and placed into the
operational state known as “SETUP MODE”. The unit can be operated as such by placing
the toggle switch (located in the top and middle portion of the main circuit board) towards the
rear of the unit. The position of the switch can be verified by looking at the circuit board and
making sure that the correct position is written next to it, or by simply viewing the customer
display screen to verify that the correct status is shown.
While in setup mode, the keypad is used as a data input device. What this means is that each
key may have more than one function, in addition to the numeric place it occupies. For a
complete list of the alternate functions, refer to Appendix A. The installer needs to be aware
of the following key functions (assuming the standard Wash Select II keypad) for correct entry
of data:
Figure 16. Standard Wash Select II Keypad
Note:
If you are installing a Canadian version Wash Select II, refer to Appendix D for more
information.
5.1 Wash Setup
This segment will step through the setup of the wash prices and names. Each of these
functions can be found under the “Wash Setup” category of the setup menu, which will be
presented on the main customer display. If you have a POS4000 connected to your system
then you may configure the Wash Select II first then configure the POS4000 next. You may
configure the Wash Select II names and prices at the POS4000 and the Wash Select II will
be updated if it is communicating at the time.
5.1.1 Wash Prices
In Setup mode scroll to the Wash Setup menu, then select and scroll to the wash that you
wish to change the price for and press (*) to select it. The wash prices should be input in
order, from the least expensive (wash 1/bottom display) to most expensive (wash 4/top
display). To disable a wash from the available choices, input a price of zero dollars followed
Document Name: Wash Select II POS Installation Manual 5.00